![]() I'm going to give my Raspberry Pi a static IP address of 192.168.0.42 by configuring /etc/network/interfaces like so (adjust address and gateway lines to match your network if necessary): auto lo Note that you will need to adjust any 192.168.0.x addresses below to match your network. If your network range is different, that's fine, use your network range instead of mine. To connect, use ssh with the password you set up above (or default raspberry if you didn't change it). Next (optionally) configure the Memory Split to give 16Mb (the minimum) to the GPU.įinally, set password to something secure using passwd.įrom now on you can disconnect the keyboard and HDMI and run the pi headless, administering it from another PC using SSH.First select Advanced options, then navigate to SSH, press Enter and select.This means you can reach the pi as raspberrypi.local on the LAN. Install avahi (may be already installed by default): sudo apt-get install avahi-daemon. When boot is complete, log in as user pi, password raspberry. Installation and Basic Configuration of RaspbianĬonnect HDMI, keyboard and ethernet (to your LAN) to pi, power up. I used a Raspberry Pi 3 - seems like the extra speed may be useful for running VPN.ĭownload of Raspbian Jessie Lite (e.g. This is a quick-and-dirty guide to setting up a Raspberry Pi as a " router on a stick" to ExpressVPN. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |